Ford XLD 1.8 litre 4 cylinder diesel Page 7 Design Features Detailed specification XLD - 55 HP at 4000 RPM XLD LP 40HP AT 2800RPM only available built on used base engine Ford parts support throughout Europe and 170 countries worldwide Engine specifications may vary as improvements are introduced Specifications are subject to change without notice and are not for engineering purposes See the Lancing Marine Boatbuilder’s Guide for Complete Installation Kit Lancing Marine reserve the right to alter specifications without notice Engine Well proven, normally aspirated. Light weight, suitable for shaft, sterndrive or jetpump installations. Fuel system Indirect rotary injection pump with pre-set minimum and maximum speed control and integral lift pump. Good starting with integral thermoswitch/ hydraulic advance and automatic high speed glow plugs. Reliability Meets high reliability and durability demands. Self air-purging fuel pump, longer life engine with a fully closed crankcase breathing system which greatly reduces oil sludge formation. Serviceability Low maintenance requirements, Easily adjustable alternator mount bracket. Low slip Poly-Vee belt. Variation to standard specification (see inside front cover) and extra optional items for this engine type Additional standard items Electric run/stop control Water injected exhaust outlet Transmission attachment parts Low oil pressure and high water temperature switches with alarm Optional items Single-groove power take-off pulley Keel cooling and dry exhaust in lieu of heat exchanger system High-rise exhaust “Dieselise” package for stern drive use Charge amplifier for domestic battery charging Engine model XLD LP XLD Max Fuel Consumption, lit/hour 9.2 12.5 Fuel feed diameter, ins (mm) 5 /16 (8) Fuel return diameter, ins 5 /16 (8) Exhaust diameter, ins (mm) 2 (50) Water intake diameter, mm 28 Coolant capacity, lit 8.5 Oil capacity, lit 5.7 Weight, Engine, Kg 184 Guide to sterngear Max. Prop. dia. for gear ratio 1.5:1 ins 17" 14" Min. Shaft Dia. St. St. ins (mm) 1 (25) Speed range for this ratio (knots) 7-20 9-25 Max. Prop. dia. for gear ratio 2:1 19" 17" Min. Shaft Dia. St. St. ins (mm) 1 (25) Speed range for this ratio (knots) 6-15 8-17 Max. Prop. dia. for gear ratio 3:1 23" 20" Min. Shaft Dia. St. St. ins (mm) 1¼ (32) Speed range for this ratio (knots) 5-10 7-12 Dimensions J & K can be found in the gearbox specification pages 9 - 15 Engine model XLD LP XLD Power Maximum H.P . 40 55 RPM Maximum 2800 4000 Torque Maximum Nm 108 Cubic capacity, litres 1.8 Bore, mm 82.5 Stroke, mm 82 Aspiration Natural Engine rotation Anti-clockwise viewed from rear Compression ratio 21.5:1 Electrics 12v earth return Alt, Amps, as available 55-90 Minimum battery size 1X65 AH 12 volt Minimum starter cable, length=size 0.6M = 25mm2 /1.2M = 40mm2 Engine operating angles Engine front down (degrees) 5 Sideways (degrees) 15 Engine front up (degrees) 15